Roving Networks WIFLY GSX Bedienungsanleitung PDF herunterladen (Seite 8)

www.rovingnetworks.com Version 1.0r 9/21/2012 8

RN-WIFLYCR-UM

COMMAND REFERENCE

Roving Networks WiFly modules support a variety of commands for configuration. This section describes these commands

in detail and provides examples.

COMMAND SYNTAX

To issue commands to the module, you send a keyword followed by optional parameters. Commands are case sensitive,

and you cannot use spaces in parameters. Use a $ to indicate a space, e.g., MY NETWORK should be written as

MY$NETWORK. Hex input data can be uppercase or lowercase. String text data, such as the SSID, is case sensitive.

You can use shorthand for the parameters. For example, the following commands are equivalent:

• set uart baudrate 115200

• set uart b 115200

• set u b 15200

NOTE: You cannot use shorthand for command keywords. For example, s uart baudrate 115200 is illegal.

You can type numbers in decimal (e.g., 115200) or hexadecimal. To enter a number in hex, use 0x<value>. For example,

the hex value FF would be entered as 0xFF.

COMMAND ORGANIZATION

There are five general command categories, as shown in Table 2.

Table 2. Command Types

Command Type

Description

Set commands

Set commands take effect immediately and are stored to memory when the save command is issued.

Get commands

These commands retrieve the stored information and display it.

Status commands

These commands display the interface status, IP status, etc.

Action commands

Use these commands to perform actions such as scanning, connecting, disconnecting, etc.

File I/O commands

Use these commands to upgrade, load and save configuration, delete files, etc.

NOTE: You must save any changes you make using the save command or the module will load the previous settings

upon reboot or power up.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 95 96

Keine Kommentare

Roving Networks WIFLY GSX Bedienungsanleitung Seite 8