Roving Networks Bluetooth Serial Adapter Betriebsanweisung PDF herunterladen (Seite 16)

RN Commands Version 4.25, 11/1/2007 Page 16 of 25

809 University Avenue • Los Gatos, CA 95032 • 1-(408) 395-6539 • [email protected]

www.rovingnetworks.com

The default profile is Serial Port Profile (SPP). The firmware also supports the DUN profile in both master and

slave modes. To change the profile, use the “S~,<num>” command.

Profile:

0 - Default SPP. (no modem control)

1 - DUN DCE (slave or gateway).

2 - DUN DTE ( master or client).

3 - MDM SPP with modem control signals.

The most common use of DUN profile is to enable a BT client to connecti to a dialup modem. For this mode, use

profile 1 (DUN DCE) via command “S~,1” . You may also want to set the Class Of Device so that clients can

recognize the device as a Bluetooth modem. The correct COD for a Bluetooth modem is 0x040210. This can be

set using the commands below:

“SC,0004”

“SD,0210”

A number of modem control signals are supported when in DUN or MDM modes and their use is described below.

4.2 PIOs used as modem control signals

The Firefly and RN-XX modules have the ability to replicate the required modem control hardware signals

automatically once a connection is made. These signals are transferred outside the data channel (using

RFCOMM control channels) and are automatically updated. The default SPP profile (profile=0) does NOT drive

these signals or report back inputs. If DUN or MDM profiles are enabled (pofile =1,2, or 3), the following

signals are automatically driven and received.

Inputs: (read and sent back over Bluetooth to the remote host).

PIO3 = DCD ( switch 2)

PIO6 = DSR (switch 3)

PIO7 = CTS (switch 4)

Inputs are ACTIVE LOW.

Outputs: (sent from the remote Bluetooth host, and driven out )

PIO10 = DTR - this is ACTIVE HIGH

PIO11 = RTS - this is ACTIVE LOW.

On the Firefly, the DIP switches can also be used to set/clear the DCD, CTS, and DSR signals. DTR and RTS are

available on the 9 pin header as well.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Keine Kommentare

Roving Networks Bluetooth Serial Adapter Betriebsanweisung Seite 16