Roving Networks RN-374 Bedienungsanleitung PDF herunterladen (Seite 25)

Advanced User Manual

www.rovingnetworks.com

rn-bluetooth-um Version 4.77 11/21/2009

809 University Avenue • Los Gatos, CA 95032 • Tel (408) 395-6539 • info@RovingNetworks.com

~ 25 ~

10.2 Dip Switch Settings

1 – RESTORE FACTORY DEFAULTS- Set this switch ON, power up unit, and toggle the switch from

ON to OFF 3 times to return the unit to factory settings.

2 - AUTO DISCOVERY – In slave mode, sets a special class of device which is used by a remote master to

auto connect. If Switch 3 also SET, the device performs a search, stores, and connects to a remote slave

which has this switch 2 set.

3 - AUTO MASTER - Device acts as Bluetooth master, auto-connects to a stored remote address. First set

the Bluetooth address of the slave device using the SR command or allow the device to auto discover and

connect by via Switch 3 AND Switch 2.

4 - DEFAULT BAUD RATE - OFF = 115K will be overridden by software baud rate configuration

commands, ON = 9600 ignores any software configuration

10.3 Instant Cable Replacement

Using two Roving Networks Bluetooth serial adapters or BluePlug USB dongle set the switches on

each device as shown below.

Power up both devices and the master will discover the slave device, store its Bluetooth address and

connect. The devices are now paired and the green LED on each device should be on solid.

After pairing, set switch 2 on both devices to OFF so that they don’t try to re-pair each time power is

cycled. Every time the devices get in proximity of one another the will connect. The master will not

attempt to connect to any other device.

To break this pairing restore the factor defaults using dip switch 1.

Master mode Slave

Auto discovery and auto Master on Auto discovery on

on off

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Keine Kommentare

Roving Networks RN-374 Bedienungsanleitung Seite 25